Reference sheet

Deluxe

AH-DLX-42

Reference sheet details

Detailed specifications, operating steps, and safety notes extracted from the product reference sheet and translated for this page.

Product sheet specifications

Automatic operation for all heater circuit stages with one touch using the remote control or touch buttons.
Two-speed turbine fan for pushing hot air.
Sharraq fan helps the unit ignite faster.
Electronic igniter.
High-quality oven-baked heat-resistant paint.
Wide glass front, 143 x 254 x 4 mm, providing a larger viewing area for the fire.

Fill the fuel tank with clean diesel up to the marked line inside the filter, then connect the heater cable to a 220V power outlet.

Set the regulator indicator to the middle position.
Press the ON button from the remote control, or the ignition button on the heater control board, and wait until the igniter glows fully red, about 20 seconds.
Open the diesel valve six full turns. The program then runs automatically for 15 minutes, starting with the igniter, then the sharraq fan, then the turbine fan.

At any time, you can stop the circuit program and directly control the igniter, sharraq fan, or turbine speed as needed.

Raise the regulator indicator two marks, then press the start button again.
Do not repeat this attempt more than two consecutive times, because it can damage the igniter.
If ignition failure repeats, check for dirty diesel, weak chimney draft, or low electrical voltage.

Adjust the heater legs so the heater becomes completely level, then lock the bracket after adjustment.
Make sure the heater stands perfectly level on the floor to ensure the diesel regulator works correctly.
On sunny days, and to remove cold air collected inside the chimney, take a cloth piece, fold it into a small ball, wet it with diesel, and light it inside the heater elbow.
At the end of winter, empty the diesel tank completely and clean it thoroughly with a cloth.
Do not use chemicals or water to clean the combustion unit, to protect the device from damage.